If your Whirlpool electric dryer has stopped heating, it can wreak havoc in your life until it really is repaired. If you are a bit handy, this article will help you find essentially the most frequent elements that could fail and bring about the dryer to cease heating.
When operating on an Top Electric Dryer, the very first thing to be conscious of is that it plugs into a 240 volt outlet. It’s really crucial to make certain that the dryer in unplugged prior to attempting any diagnostics using the dryer.
You can find a number of elements in a dryer that will fail and cause it to not dry. Working with a multi-meter, these elements can easily be checked from accessing them at the rear on the dryer.
Very first, make sure the dryer cord has been removed in the outlet. Subsequent detach the vent from the rear on the dryer and move it towards the side. You will have to eliminate ten 1/4 sockets screws to get rid of the back panel. From here you are able to check the heating element, thermal fuse, hi-limit thermostats and operating thermostat.
The heater is located around the right side. To check the heating element, get rid of the two red wires attached to the heater terminal situated on bottom on the heater casing. Test the terminals together with your multi-meter and also you should really have continuity. If not, then the heating element is faulty and can need to be replaced.
Another component that fails normally is definitely the thermal fuse which is positioned on the left side. The thermal fuse is white, thin and about two inches in length. Check this for continuity. If the fuse is negative, you’ll need to ensure that the dryer venting major from the dryer to outside is clear. If it gets too hot inside the dryer, this non reset able fuse will fail.
Attached for the heating element casing are two hi-limit thermostats that may be tested for continuity. Unplug the wires and test with your Washer And Dryer. 1 thermostat is located around the prime and the other around the bottom close to the heating element terminals. If these thermostats fail, they may reduce power for the heating element.
Finally, in the rear on the dryer, the operating thermostat may be tested. The operating thermostat cycles the heat to turn on and off as a way to sustain an average temperature close to 155 degrees around the standard cycle. It’s situated just under the thermal fuse. Verify the continuity between the two larger terminals on the thermostat. When the it doesn’t have continuity, it is going to need to be replaced.